top of page

Cortez Conversions 112H Side Plate Build

This tutorial is for New Style and Old Style side plates. It is also recommended that you visit and download a schematic for the 112H (3/0)Special (Red) for
Fig.1 Exploded View. Our kit comes with the Items listed below.
  • 2 stainless steel bearing cups with o-rings and 2 ABEC-5 stainless steel bearings.
  • Color matched Eccentric lever with 2 o-rings and stainless steel washers.
  • Delrin Eccentric Sleeve
  • Stainless Steel Clicker button, Nylon washer, Penn Dog, Cir-clip,   Clicker spring , and 2 stainless steel mounting screws.
  • 10 Stainless Steel Plate screws
  • Left and Right Side Plates
Fig.2 What you will need to complete this build;
  • Star Drag Wheel
  • Handle screw
  • Handle lock screw
  • Eccentric screw
  • Eccentric spring
  • Eccentric
  • Eccentric Jack
  • 2 Upper & 2 Lower bridge screws
  • Dog & Dog spring
  • Pinion
  • Pinion Yoke
  • 2 Clutch Springs
  • Bridge With sleeve
  • Gear Sleeve 
  • Main Gear
  • Drag Washer set
These parts can be acquired either by a donor reel or they can be purchased here at 112H (3/0) Special (Red)
Fig.2A Bearing Cups with bearings and o-rings installed. Note: The Bearing Cups are not the same for both side plates. The cup with the Post is the pinion side cup.
Fig.3 and 3A Left Side Plate assembled. Note: The Nylon washer goes between the clicker button and the left side plate in Fig.3A
Eccentric Lever O-ring Installation
To view a brief tutorial of this process, click on the image.
Fig. 4 Right Side Plate with Eccentric and Eccentric Spring and Bearing installed.
Fig.4A Right Side Plate, with Bearing Cup, Delrin Eccentric Sleeve, Eccentric Lever, metal washer, and Eccentric screw. Note: Metal washer goes in-between Eccentric Screw and Eccentric Lever.
Fig.5 and 5A Right side plate complete with bridge assembly, drag star and bridge screws
bottom of page